Joe from American Builders tells us about the DuoFast DF225C Coil Siding Nailer.
What gauge nailer would work best for ship lap log siding?
Jul 31, 2009 by Pilgrim Traveler | Posted in Decorating & Remodeling
I'm looking to buy a pneumatic nailer and can't commit oneself to whether to get a 15 or 16 Gage. I will also be using it to install door and window trim, assemble bookcases, etc. The siding project is white pine nailed through the edge at the top and
You will prerequisite a 16 ga. straight finish nailer. This will shoot nails from 3/4" to 2-1/2", which should cope with most of your needs. Do you already have a compressor? Porter-Cable makes several different kits which include a compressor,
woodtick314 | Jul 31, 2009
I don't speak one's mind technical......
*burst into tears and runs away crying*
Peace.
Trixie Taint | Jul 31, 2009
Can a coil roofing nailer be used to install vinyl siding?
Aug 01, 2009 by stashu | Posted in Maintenance & Repairs
Yes and No....
A archetype coil nailer would drive the nail in too tight... you actually need to be able to move the vinyl siding side to side right-minded a bit, when it is fastened to the wall.
However, a coil nailer CAN be modified by
thewrangler_sw | Aug 01, 2009
I am installing cedar shakes as exterior house siding, waht, if any, nailer could I use.?
Jun 01, 2006 by Paula O | Posted in Do It Yourself (DIY)
They enterprising double hot-dip gavanized nails specifically for cedar shakes and cedar shingles. They are a lot thinner than a benchmark roofing nail to resist splitting, and come in lengths of 1 1/4"- 2 1/4". The particularly-sharp points
BearDown | Jun 01, 2006
What is the most easy way to fasten hardie plank lap siding?
Mar 19, 2008 by 1GOODGUY | Posted in Maintenance & Repairs
Im upsetting to install 12'x8" lap siding over masonite. I have very little help and experience and even less funds. I am mechanically inclided as an electrician. I was told to use a circles nailer to prevent damaging the suface of the siding but
loop siding nailer and j hardie 2 3/8" plastic coated galvanized ring shank nails.....or hammer and dead ringer galvanized nails(dont rust)
“That salute hitting the house, it was like an air-nailer constantly going off,” said Eric Johnson. As well as fixing hurt to his roof and siding, Johnson now has to deal with a garage that's on the verge of collapse. He said the only emotional attachment holding it
